Low Power Area Efficient Arithmetic and Logical Control Unit Using Reversible Logic

International Research Journal of Engineering and Technology (IRJET) e-ISSN: 2395 -0056
Volume: 04 Issue: 03 | Mar -2017 www.irjet.net p-ISSN: 2395-0072
© 2017, IRJET | Impact Factor value: 5.181 | ISO 9001:2008 Certified Journal | Page 305
LOW POWER AREA EFFICIENT ARITHMETIC AND LOGICAL CONTROL
UNIT USING REVERSIBLE LOGIC
Karthikeyan. S1, Priyanga. K2, Priyanka. P3, Vigneshkumaran. A4
1Assistant Professor, Department of ECE, Jansons Institute of Technology, Coimbatore, Tamil Nadu, India
2,3,4Students, Department of ECE, Jansons Institute of Technology, Coimbatore, Tamil Nadu, India
---------------------------------------------------------------------***---------------------------------------------------------------------
Abstract - In this project we are designing a 8 bit
arithmetic and logical unit with the help of reversible
logic. This ALU consists of 10 operations, 4 logical and 6
arithmetic operations. The logical operation include and,
or, ex-or and ex-nor. The arithmetic operation performed
by this gate includes set, clear, increment, 1’s complement,
2’s complement and transfer of input. Reversible logic is
gaining interest in the recent years due to its less power
consuming and less heat dissipating characteristics. Unlike
the irreversible gates that dissipates energy, the reversible
computation reduce heat dissipation. The loss of
information is associated with loss in physics is requiring
that one bit information lost dissipates “KT ln2 of energy”.
In order to overcome the loss of information we go for
reversible computation. The parameters that define an
optimum reversible logic based ALU are low quantum cost,
reduced garbage outputs and minimum number of
reversible gates used. Based on the above constraints of
the reversible logic we have designed a ALU with single
reversible logic gate namely RC-1 gate. This design is
developed using Xilinx 13.4suite, verilog software. It is
designed so as to perform 8 bit inputs for both logical and
arithmetic operations.
Key Words: RC-1 gate, reversible computation, garbage
outputs, quantum cost; arithmetic and logic operations.
1.INTRODUCTION:
The recent research in VLSI technology is the reversible
logic to reduce the power dissipation is the major area of
concern. The reversible logic is associated with the
combinational circuits without the delay or flip-flops.
This was first brought out by Landauer who discovered
the power dissipation in conventional or irreversible
gates. He stated that only one of the inputs out of 2 given
input is given to the output information and the other bit
is dissipated. This power loss is major disadvantage in
conventional gates. Bennet gave a mathematical proof to
this power dissipation is in the form of KT ln 2. This led to
the development of reversible logic. The concept of the
reversible logic focuses on the equal number of input and
outputs. In case of reversible logic each input gives an
unique output as per quantum mechanics and so as to be
mapped as one to one. This kind of output can be useful
to get the inputs given and also reduce the loss of power.
Quantum mechanics play a vital role in the construction
of reversible logic or the quantum gates.
1.1 REVERSIBLE LOGIC:
Reversible are circuits that have one to one mapping
between vectors of inputs and outputs, thus the vector of
input states can be always reconstructed from the vector
of output states. Reversible circuit can realize unbalanced
function only with additional inputs and garbage output.
In conventional logic gate the 2 inputs form a single
output, which leads to the power dissipation in the form
of heat. This was found by Landauer and the scientist
Bennet proved it to be true by defining the loss of heat in
terms of KT ln 2 joules. The reversible logic is formed in
order to reduce this dissipation in the way that both the
inputs are involved to give 2 sets of output that is
believed to t the same. It also provides the unique output
and output can be used to retrieve the inputs as they are
one to one mapped.
1.2 REVERSIBLE LOGIC GATES:
A reversible logic gate is an n-input n-output logic
devices with one-to-one mapping. This helps to
determine the outputs from inputs and also inputs can
be uniquely recovered from outputs. A reversible circuit
should be designed using minimum number of reversible
logic gate. Reversible logic gate consists of garbage
output and quantum cost. Garbage output refers to the
number of unused output present in a circuit, which
cannot be avoided as these are very essential to achieve
reversibility. Quantum cost refers to the cost of the
circuit in terms of cost of primitive gate (1*1 or 2*2).

1.3 BASIC REVERSIBLE LOGIC GATE
1.3.1 FREDKIN GATE:
Fredkin gate is 3*3 reversible gate. The figure shows
the input and output of the gate. The quantum cost of
fredkin gate is 5. It is used as parity preserving gate and
universal reversible gate.
1.3.2 TOFOLLI GATE:
Tofolli gate is a 3*3 reversible gate. The input vector and
output vector are shown in the figure. The quantum cost of
tofolli gate is 5. It is suitable for universal gate operations.
1.3.3 PERES GATE:
Peres gate is a 3*3 reversible gate. The input and output
vectors are shown in the given figure. The quantum cost of
the peres gate is 4. Two peres gates can be used for the
design of full adder.

1.3.4 RC-1 GATE:
Rc-1 gate is 3*3 reversible gate. The input and outputs are
shown in below figure. The quantum cost of the gate is 4.
Due to its less quantum cost it is used for this proposed
design. It can be used as a one bit comparator
2. PROPOSED WORK
2.1 ARITHMETIC AND LOGICAL UNIT
The ALU consists of a 3 input multiplexer and a 2 RC-1
gate to perform arithmetic and logical operation in case of
8 bit. This multiplexer performs the action so as to select
the combination of input. When the input of the mux is
given as Z0’ Z1’ when the ‘a=0’, then the multiplexer
produces a output to select only the arithmetic operation.
When the input of the mux is given as Z0’ Z1 when the ‘a=1’,
then the multiplexer produces a output to select only the
logical operation. When the input of the mux is given as Z0
Z1’ when the ‘a=0’, then the multiplexer produces a output
to select only the arithmetic and logical operation when
the input A=0. When the input of the mux is given as Z0 Z1
when the ‘a=1’, then the multiplexer produces a output to
select only the arithmetic and logical operation when input
A=1. The block diagram and the detailed diagram of the
ALU is shown below.
2.2 ARITHMETIC OPERATION
The arithmetic operation is performed using a RC-1 gate.
The 3*3 reversible gate performs the following operations
they are set, clear, transfer of one input,1’s complement,2’s
complement and increment operations for both 1 and 8
bit.

2.3 LOGICAL OPERATION
The logical unit consists of a RC-1 gate to perform logical
operations such as AND, OR, EX-OR and EX-NOR.
2.4 TABLE OF OPERATIONS
The below table shows the total operation of the proposed
work. It is all built using a RC-1 gate. This table is given for
1 bit operation. The similar is used for the * bit operations.
2.5 HARDWARE AND SOFTWARE:
This design is implemented using FPGA trainer kit of the
family of Spartan 3E.The details regarding the hardware
used is given below.
Program was developed using XILINX software in order to
develop this design. All the bit operations from 1-, 4- and
8- bit operations were performed and verified for the
results.
3. SIMULATION RESULTS
Simulation results are the result of the proposed design.
The below are the simulation results of the ALU obtained
for inputs b=10101010, c=01010101and d=11110000 for
the following conditions.
For z=00 and a=0, the results obtained for 8 bit inputs are
arithmetic.

For z=00 and a=1,the results obtained are arithmetic
For z=01 and a=0, the result obtaied are logical.
For z=01 and a=1, the results obtained are logical.
For z=10 and a=0, the results obtained are a combination
of arithmetic and logical but its when a=1 of arithmetic and
d=0 of logical.

For z=10 and a=1, the results obtained are a combination
of arithmetic and logical but its when a=0 of arithmetic
and d=1of logical.
4. CONCLUSION
4.1 COMPARISION WITH EXISTING WORK:
The proposed model has a great advantage over the
existing design as it can be completed using a single gate
namely, RC-1 reversible logic gate. This gate can be used as
to perform the arithmetic, logical and multiplexer
operation without any garbage output. It can also be used
as adder subtractor of fewer garbage outputs than the
others. This can simultaneously reduce the power
consumption and also reduce the manufacture of other
gate in large amount. The quantum cost of this RC-1 gate is
4 which is the least and this kind of design can give very
few garbage outputs. Unlike other gate that perform 10- 16
operations for a 8 bit ALU this proposed design gives only
10 outputs but with zero garbage outputs which makes the
design more efficient
ACKNOWLEDGEMENT
We thank our project coordinators, all our professors, our
Head of the department for their unconditional love and
support in developing this project. We also thank the
department of ECE and the management authorities of
Jansons Institute of Technology for their encouragement.
All your guidance have helped us achieve this mighty goal.
REFERENCES:
[ 1]. C.H. Bennett, Logical reversibility of computation,
IBM Journal of Research and Development, 17(6), 1973,
525–532.
[2] Kamaraj Arunachalam, Mailchamy Perumalsamy,
Kalyana Sundaram, J.Senthil Kumar, Design and
implementation of a reversible logic based 8-bit arithmetic
and logic unit, July 2014.
[3] Rahul Kumar, Subhangini Ugale, Vipin S. Bhure, Design
and Implementation Arithmetic logic Unit, Feb 2016
[4] Shaveta Tharkal, Dipali Bansal, Design & Optimization
of Reversible Logic Based ALU Using ACO, May 2016
[5] Deepa.G, Madhuri.E, Malashree.S, Mamatha.k,
Supriya.K, Design and Implementation of 32- bit ALU with
16 operations using reversible logic, May 2016

Low Power Area Efficient Arithmetic and Logical Control Unit Using Reversible Logic

Recommended

More Related Content

What's hot (18)

Similar to Low Power Area Efficient Arithmetic and Logical Control Unit Using Reversible Logic (20)

More from IRJET Journal (20)

Recently uploaded (20)

Low Power Area Efficient Arithmetic and Logical Control Unit Using Reversible Logic