IRJET- RGB Image Compression using Multi-Level Block Trunction Code Algorithm

International Research Journal of Engineering and Technology (IRJET) e-ISSN: 2395-0056
Volume: 06 Issue: 11 | Nov 2019 www.irjet.net p-ISSN: 2395-0072
© 2019, IRJET | Impact Factor value: 7.34 | ISO 9001:2008 Certified Journal | Page 9
RGB Image Compression using Multi-level Block Trunction Code
Algorithm
Anjali Pachauri1, Prof. Gurpreet Singh2
1Research scholar, Electronics & Communication Department, Trinity Institute of Technology & Research, Bhopal
2Professor, Electronics & Communication Department, Trinity Institute of Technology & Research, Bhopal
----------------------------------------------------------------------***---------------------------------------------------------------------
Abstract - This paper aims to proposed multi-level block truncation code (BTC) based image compression of continuous tone
still image to achieve low bit rate and high quality. The algorithm has been proposed by combining bit map and quantization. The
algorithms are proposed based on the assumption that the computing power is not the limitingfactor. Theparametersconsidered
for evaluating the performance of the proposed methods are compression ratioandsubjectivequalityofthereconstructedimages.
The performance of proposed algorithm including color image compression, progressive image transmission is quite good. The
effectiveness of the proposed schemes is established by comparing the performance with that of the existing methods.
Key Words: Block Truncation Code (BTC), Bit Map, Multi-level, Quantization
1. INTRODUCTION
With the advent of the multimedia era and the growth of digital packet networks the total amount of image data accessed and
exchanged by users has reached a huge value of several terabytes. Therefore, the need for compression of continuous tone still
images has grown tremendously enormous. Image compression maps an original image in to a bit stream suitable for
transmissionand storage. The number of bits required to represent the compressedimageshouldbesmallerthanthatrequired
for the original image. Compression is specified in terms of number of bits per pixel (bpp) or Compression Ratio (CR) [1]. The
subjective quality of compressed image is specified by Peak Signal to Noise Ratio (PSNR). Digital image compression methods
can be divided into two broad categories: ‘lossless’ and ‘lossy’compressionmethods.Lossycompressionmethodsarenecessary
to achieve high compression ratio. In a lossy compression system, the reconstructed image is not identical to the source image
and very high compression ratio is possible at the expense of loss of visual quality [2]. Lossy compression algorithms are based
on the principle of removal of subjective redundancy and are extremely important in applications such as transmission of still
images over the internet where certain amount of distortion may be tolerated. Traditional image compression techniquessuch
as run length coding, arithmetic coding and Huffman code are lossless coding schemes. Statistical redundancy present in the
image can be effectively compressed using such lossless compression but the compression gain achieved is low [3-4]. The best
compression ratio thatcan be achieved with currentlossless compression standardssuchas Joint Photographic Experts Group
(JPEG) is around 3 to 4. Transform coding is a widely applied method forlossy imagecompression.Imagetransformseffectively
decorrelate the pixels so that pixels representing similar events in the image are grouped together according to their spatial or
spectral properties.After transformation, the useful informationisconcentratedintoafewofthelow-frequencycoefficientsand
the Human Visual System is more sensitive to such low spatial frequency information than to high spatial frequency [5]. This is
achieved through certain orthogonal transforms such as like Karhunen- Loeve Transform (KLT), Discrete Cosine Transform
(DCT), Discrete Sine Transform (DST), Walsh Hadamard Transform etc. Thus coding of transform coefficients can lead to
substantial data reduction and it is currently one of the best coding techniques known. A primary example of the transform
coding is the DCT-based JPEG image compression standard prepared by the ISO/IEC/JTC1/ SC2/WG10 committee popularly
called the Joint Photographic Experts Group. It performs the lossy compression of the still images. However, it suffers from the
drawback of blocking artifacts. Recently, the application of Discrete Wavelet Transform (DWT) in image compression has
received significant attention and many wavelet based image compression algorithms have been proposed. The wavelet
transform decomposesa signal into its various frequency components. In the case of natural images, one obtainsmanysmallor
zero-valued coefficients corresponding to the high-frequency components of the image. Due to the large number of small
coefficients, the transformed signal is often easier to code than the original signal itself [6]. JPEG 2000 standard is based on
transform coding employingDWT. It achieves high compressionratioandimprovedsubjectivequalityespeciallyatlowbitrates
than the previous DCT-based JPEG [7].
2. ELEMENTS OF LOSSY IMAGE COMPRESSION SYSTEM
In transform based image compression, the imageissubjectedtotransformationandthenthetransformeddataareencoded
to produce the compressed bit stream. Thegeneralstructureofatransform-basedimagecompressionsystemisshowninFigure
1. There are two versions of transform coding. One is frame based and the other is the block based. The block based approach
requires fewer computations and allows adaptive quantization of coefficients.

In Figure 1, X represents the original image pixel values; Yi denotes the transformed values of the original image. All the
transformed coefficients arethen quantized and entropy coded which are represented by Ci. These compressedbitstreamsare
either transmitted or stored. Reconstructed image can be obtained by decompressing the coded signal. The goal is to design a
system so that the coded signal Ci can be represented with fewer bits than the original image X [8].
In the 1980’s, almost all transform based compression approaches were using the DCT. Later, the trend moved to compression
schemes based on the DWT. DWT overcomes the effect of blocking artifacts associated with DCT. Perhaps the most significant
improvement in conventional coding is achieved by the use of arithmetic coders instead of simple Huffman coders, which
increases the compression ratio by 5-8%. However, the multimedia content in daily life is growing exponentially; therefore, a
performance gain of about 10% in ten years does not satisfy the demand. Therefore, researchers have been looking for new
solutions that could solve the problem of the stagnating image compression performance.
Fig -1: Transform-based image compression system
Finally, the quantized coefficients are coded to produce the compressed bit stream. The coding process typically exploits a
statistical model in order to code symbols with fewer bits for symbolsthathashigherprobabilityofoccurrence.Indoingso,the
size of the compressed bit stream is reduced. Assuming thatthetransform employedis trulyinvertible,theonlypotential cause
for information loss is in the coefficient quantization, as the quantized coefficients are coded in a lossless manner [9]. The
decompression process simply mirrors the process used for compression. The compressed bit streamisdecodedto obtainthe
quantized transform coefficients. Then, the inverse of the transform used during compression is employed to obtain the
reconstructed image.
3. IMAGE QUALITY MEASURES
It is a major task in evaluating the image quality of an image compression system to describe the amount of degradation inthe
reconstructed image. In the case of lossy compression, the reconstructed image is only an approximation to the original. The
difference between the original and reconstructed signal is referred to as approximation error or distortion. Generally, the
performance is evaluated in terms of compression ratio and image fidelity[10].A goodimagecompressionalgorithmresultsin
a high compression ratio and high fidelity. Unfortunately, both requirements cannot be achieved simultaneously. Although
many metrics exist for quantifying distortion, it is most commonly expressed in terms of means squared error (MSE) or peak-
signal-to-noise ratio (PSNR). The performance of image compression systems is measured by the metric defined in equations
(1) and (2). It is based on the assumption that the digital imageisrepresentedas 21 NN  matrix,where 1N and 2N denotethe
number of rows and columns of the image respectively. Also, ),( jif and ),( jig denote pixel values of the original image
before compression and degraded image after compression respectively.
Mean Square Error (MSE)
 

2 1
1 1
2
21
)),(),((
1 N
j
N
i
jigjif
NN (1)

Peak Signal to Noise Ratio (PSNR) in dB
)
255
(log10
2
10
MSE

(2)
Evidently, smaller MSE and larger PSNR values correspond to lower levels of distortion. Althoughthesemetricsarefrequently
employed, it can be observed that the MSE and PSNR metrics do not always correlate well with image quality as perceived by
the human visual system. For this reason, it is preferable to supplement any objective lossy compression performance
measurement by subjective tests such as the Mean Opinion Score (MOS) to ensure that the objectiveresultsarenotmisleading
[11].
Sometimes compression is quantified by stating the Bit Rate (BR) achieved by compression algorithm expressed in bpp (bits
per pixel). Another parameter that measures the amount of compression is the Compression Ratio (CR) which is defined as
sizeimageCompressed
sizeimageOriginal
CR 
(3)
4. PROPOSED METHODOLOGY
Proposed Encoder and decoder block of the multi-level block truncationcodealgorithmisshowniffigure2.Encoderpartofthe
proposed algorithm shows that the original image is divided into three parts i.e. R component,Gcomponentand Bcomponent.
Each R, G, B component of the image is divided into non overlapping block of equal size and threshold value for eachblock size
is being calculated.
Threshold value means the average of the maximum value (max) of ‘k × k’ pixels block, minimum value (min) of ‘k × k’ pixels
block and 1m is the mean value of ‘k × k’ pixels block. Where k represents block size of the color image. So threshold value is:
(4)
Each threshold value is passing through the quantization block. Quantization is the process ofmappinga setofinputfractional
values to a whole number. Suppose the fractional value is less than 0.5, then the quantization is replaced by previous whole
number and if the fractional value is greater than 0.5, then the quantization is replaced by next whole number. Each
quantization value is passing through the bit map block. Bit map means each block is represented by ‘0’ and ‘1’ bit map. If the
Threshold value is less than or equal to the input image value then the pixel value of the image is represent by ‘0’ and if the
threshold value is greater than the input image value then the pixel value of the image is represented by ‘1’.
Bit map is directly connected to the high and low component of the proposed decoder multi-level BTC algorithm.High(H)and
low (L) component is directly connected to the bit map, bitmap converted the ‘1’ and ‘0’ pixel value to high and low pixel value
and arrange the entire block.
(5)
(6)
Wi represent the input color image block, q is the number of zeros in the bit plane, p is the number of ones in the bit plane. In
the combine block of decoder, the values obtained from the pattern fitting block of individual R,G,Bcomponentsarecombined
after that all the individual combined block are merged into a single block . Finally compressed image and all the parameter
relative to that image will be obtained.
3
minmax 1m
T



5. SIMULATION RESULT
Figure 2; shows the Lena image of 2×2 block pixel. In this figure 2 (a) show the random image of the Lena image and resize the
image of the 512×512 in the Lena image shown in figure 2 (b). The compressed image is 2×2 block pixel of Lena image shown
in figure 2 (c) respectively.
Fig -2: Multi-level BTC Algorithm applied on Satellite Image of block size 4×4
As shown in table 1 the peak signal to noise ratio (PSNR) and computation time are obtained from the proposed multi-level
block truncation code algorithm. The values obtained for various block sizes is the average value of red, blue and green
component of the image.
Table -1: Comparative Study of Proposed Method on different images
Image MSE PSNR
Flower
Image
Previous 498.52 38.15
Proposed 479.12 40.21
Baboon
Image
Previous 458.25 41.62
Proposed 439.98 43.21
(a) (b)
(c) (d)
(e) (f)

Lena
Image
Previous 501.326 36.91
Proposed 489.278 39.87
Table -2: PSNR Calculate of R, G, B channel refinement
6. CONCLUSION
The proposed method improved the quality of de-noised imageespeciallyforrandomvaluedimpulsenoise.Proposedmethodis
evaluated on the standard images like Flower, lena and baoon Images. Peak Signal Noise to Ratio & Mean Square Error values
proven that proposed method outperforms the existing method.
REFERENCES
[1] C. Senthil kumar, “Color and Multispectral Image Compression usingEnhancedBlock TruncationCoding[E-BTC]Scheme”,
accepted to be presented at the IEEE WiSPNET, PP. 01-06, 2016 IEEE.
[2] Jing-Ming Guo, Senior Member, IEEE, and Yun-Fu Liu, Member, IEEE, “Improved Block Truncation Coding UsingOptimized
Dot Diffusion”, IEEE TRANSACTIONS ON IMAGE PROCESSING, VOL. 23, NO. 3, MARCH 2014.
[3] Jayamol Mathews, Madhu S. Nair, “Modified BTC Algorithm for Gray Scale Images using max-minQuantizer”,978-1-4673-
5090-7/13/$31.00 ©2013 IEEE.
[4] Ki-Won Oh and Kang-Sun Choi, “Parallel Implementation of Hybrid Vector Quantizerbased Block Truncation Coding for
Mobile Display Stream Compression”, IEEE ISCE 2014 1569954165.
[5] Seddeq E. Ghrare and Ahmed R. Khobaiz, “Digital Image Compression using Block Truncation
Coding and Walsh Hadamard Transform Hybrid Technique”, 2014 IEEE 2014 International Conference on Computer,
Communication, and Control Technology (I4CT 2014), September 2 - 4, 2014 - Langkawi, Kedah, Malaysia.
[6] M. Brunig and W. Niehsen. Fast full search block matching. IEEE Transactions on Circuits and Systems for Video
Technology, 11:241 – 247, 2001.
[7] K. W. Chan and K. L. Chan. Optimisation of multi-level block truncation coding. Signal Processing: Image Communication,
16:445 – 459, 2001.
[8] C. C. Chang and T. S. Chen. New tree-structured vector quantization with closed-coupled multipath searching method.
Optical Engineering, 36:1713 – 1720, 1997.
[9] C. C. Chang, H. C. Hsia, and T. S. Chen. A progressive image transmission scheme based on block truncationcoding.InLNCS
Vol 2105, pages 383–397, 2001.
[10] William H.Equitz, 1989: “A New Vector Quantization Clustering Algorithm” IEEE Transactions on Acoustics, Speech and
Signal Processing, Vol. 37, No. 10, pp. 1568-1575.

IRJET- RGB Image Compression using Multi-Level Block Trunction Code Algorithm

Recommended

More Related Content

What's hot (18)

Similar to IRJET- RGB Image Compression using Multi-Level Block Trunction Code Algorithm (20)

More from IRJET Journal (20)

Recently uploaded (20)

IRJET- RGB Image Compression using Multi-Level Block Trunction Code Algorithm