Analysis of Image Compression Using Wavelet

IOSR Journal of Electronics and Communication Engineering (IOSR-JECE)
e-ISSN: 2278-2834,p- ISSN: 2278-8735.Volume 6, Issue 1 (May. - Jun. 2013), PP 59-64
www.iosrjournals.org
www.iosrjournals.org 59 | Page
Analysis of Image Compression Using Wavelet
Amar Nath Gupta1
, Bikash Chandra Sahana2
, Vijay Kumar Anand3
(Dept. of ECE, NIT Patna, India)
Abstract : Recently, wavelet has a powerful tool for image compression. This paper analysis the mean square
error, peak signal to noise ratio and bit-per-pixel ratio of compressed image with different decomposition level
by using wavelet.
Keywords – Image, wavelet, BPP, PSNR, MSE
I. INTRODUCTION
Image is a two dimensional function f(x,y), where x and y are spatial(plane) coordinates, and the
amplitude of f at any pair of coordinates(x,y) is called the intensity of the image at that point. Wavelets are a
fairly simple mathematical tool that cuts up data or functions into different frequency components and then
studies each component with a resolution matched to its scale [1]. The wavelet is a powerful tool which gives
the spatial and frequency characteristics of an image, on the other hand, Fourier transform gives only frequency
characteristics of an image [2].
Now beginning from a given image, the aim of compression is to reduced the number of bits needed to
represents it, while storing information of acceptable quality. The effective solution for this problem is wavelet.
The complete chain of compression includes iterative phases of quantization, coding and decoding, in addition
to the wavelet processing itself [3].
II. BACKGROUND & EQUATIONS
A. Compression performance
Two quantitative measures giving equivalent information are commonly used as a performance
indicator for the compression:
The compression ratio CR, which means that the compressed image is stored using only CR% of the initial
storage size.
The Bit-per-pixel ratio BPP, which gives the number of bits required to store one pixel of the image.
B. Perceptual Quality
Two measures are commonly used to evaluate the perceptual quality:-

Analysis of image compression using wavelet
The Mean Square Error (MSE).It represents the mean squared error between the compressed and the original
image and is given by
The Peak Signal to Noise Ratio (PSNR).It represents a measure of the peak error and is expressed in decibels. It
is defined by:
SPIHT Algorithm:-SPIHT algorithm was introduced by Said [4] and Pearlman [5].It is a simple,
efficient and powerful compression algorithm. This algorithm gives the idea to compute the highest PSNR value
of a variety of images. The important feature of this algorithm is that at any point during the decoding of an
image, the quality of the displayed image is the best that can be achieved for the number of bits input by the
decoder up to that moment.
The wavelet coefficients can be referred as ci,j. In a progressive transmission method, the decoder starts
by setting the reconstruction image to zero. It then inputs (encoded) transform coefficients, decodes them and
uses them to generate an improved reconstruction image. The main aim in progressive transmission is to
transmit the most important image information first. SPIHT uses the mean square error (MSE) distortion
measure.
SPIHT Coding:-It is important to have the encoder and decoder test sets for significance in the same
way, so the coding algorithm uses three lists called list of significance pixels (LSP), list of insignificant pixels
(LIP), and list of insignificant sets (LIS).
1. Intialization: Set n to [log2maxi,j(ci,j)] and transmit n. Set the LSP to empty. Set the LIP to the coordinates of
all the roots (i,j) ϵ H. Set the LIS to the coordinates of all the roots (i,j) ϵ H that have descendents.
2. Sorting pass:
2.1 for each entry (i,j) in the LIP do:
2.1.1 output Sn(i,j);
2.1.2 if Sn(i,j)=1, move (i,j) to the LSP and output the sign of ci,j;
2.2 for each entry (i,j) in the LIS do:
2.2.1 if the entry is of type A, then
Output Sn(D(i,j)); then
For each (k,1) ϵ O (i,j) do:
Output Sn(k,1);
If Sn(k,1)=1,add (k,1) to the LSP,
Output the sign of ck,1;
If Sn(k,1)=0,append (k,1) to the
LIP;
If L(i,j) is not equal to 0, move (i,j) to the end of the LIS, as a type-B entry and go to step 2.2.2; else,
remove entry (i,j) from the LIS;
2.2.3 if the entry is of type B, then
Output Sn(L(i,j));
If Sn(L(I,j))=1,then
append each (K,1) ϵ O(i,j) to the LIS as a type
A entry:
Remove (i,j) from the LIS:
3. Refinement pass: for each entry (i,j) in the LSP, except those included in the last sorting pass (the one with
the same n), output the nth most significant bit of |cij|;
4. Loop; decrement n by 1 and go to step 2 if needed.
EZW Algorithm:- EZW algorithm is the powerful algorithm based on wavelet based image compression. The
other algorithm is generated by the help of EZW algorithm.EZW algorithm was introduced by Shapiro [6].EZW
means embedded zerotree wavelet. EZW approximates higher frequency coefficients of a wavelet transformed
image. The EZW algorithm is as follow:
1. Initialization: Set the threshold T to the smallest power of 2 that is greater than max (i,j)|ci,j|/2,where ci,j are the
wavelet coefficients.
2. Significance map coding: Scan all the coefficients in a predefined way and output a symbol when |ci,j|>T,
when the decoder inputs this symbol, it set sets cij=±1.5T

3. Refinement: Refine each significant coefficient by sending one more bit of its binary representation. When
the decoder receives this, it increments the current coefficient value by ±0.25 T
4. Set T=T/2, and go to step 2 if more iterations are needed.
EZW coding: A wavelet coefficient ci,j is considered insignificant with respect to the current threshold
T if |ci,j|=T. The zerotree data structure can be constructed from the following experimental result: If a wavelet
coefficients at a coarse scale (i.e., high in the image pyramid) is insignificant with respect to a given threshold T,
then all of the coefficients of the same orientation in the same spatial location at finer scales (i.e., located lower
in the pyramid) are very likely to be insignificant with respect to T. In each iteration, all the coefficients are
scanned in the order. This guarantees that when a node is visited, all its parents will already have been scanned.
Each coefficients visited in the scan is classified as a zerotree (ZTR), an isolated zero (IZ), positive
significant (POS), or negative significant (NEG).A zerotree root is a coefficient that is insignificant and all its
descendants ( in the same spatial orientation tree) are also insignificant. Such a coefficient becomes the root of a
zerotree . It is encoded with a special symbol (denoted by ZTR). When the decoder inputs a ZTR symbol.
III. SIMULATION RESULT
The image compression techniques discussed in section II were applied to a variety of images using
Matlab® software.
Lena, Barbara and boat image (512*512)
Table:-
Image
Type
Wavelet Compression
Parameter
Decomposition
Level
PSNR MSE BPP
Lena.bmp
(512*512)
Haar EZW,
Nb
Encoding
Loops,8
1 51.72 0.4376 7.7551
2 44.55 2.282 3.6219
3 39.72 6.938 1.7131
4 35.74 17.35 0.83084
5 32.03 40.78 0.38043
SPIHT,
Nb
Encoding
Loops,8
1 37.65 11.16 7.0175
2 36.95 13.11 2.3537
3 34.15 25 0.87985
4 31.12 50.23 0.34708
5 28.1 100.6 0.13486
Image Type Wavelet Compression
Parameter
Decomposition
Level
PSNR MSE BPP
barbara.bmp
(512*512)
Haar EZW,
Nb
Encoding
Loops,8
1 53.18 0.3126 8.9462
2 45.48 1.843 5.2842
3 39.54 7.234 3.1143
4 34.18 24.86 1.7453
5 28.95 82.86 0.81506
SPIHT,
Nb
Encoding
Loops,8
1 37.49 11.59 7.8746
2 35.59 17.94 3.2138
3 32.21 39.05 1.4844
4 27.83 107.1 0.66656
5 24.24 245.2 0.23734

Image
Type
Wavelet Compression
Parameter
Decomposition
Level
PSNR MSE BPP
boat.bmp
(512*512)
Haar EZW,
Nb Encoding
Loops,8
1 53.37 0.2993 9.169
2 44.94 2.085 5.0627
3 38.34 9.534 2.6319
4 33.8 27.13 1.2751
5 30.1 63.54 0.58871
SPIHT,
Nb Encoding
Loops,8
1 38.05 10.19 7.705
2 35.51 18.29 2.9371
3 32.36 37.81 1.1774
4 29.16 78.93 0.49246
5 26.05 161.5 0.19269
4 33.32 30.25 1.4442
5 29.8 68.16 0.6683
Graph:-
PSNR Vs Decomposition level using Haar Wavelet

MSE VS Decomposition Level using Haar wavelet
BPP VS Decomposition level using Haar wavelet

IV. CONCLUSION
We see that higher the PSNR value gives the better the quality of the compressed or reconstructed
image. Higher the MSE values degrade the quality of the compressed or reconstructed image. Also, increasing
the decomposition level Bit-per-pixel ratio decreases.
REFERENCES
[1] Ingrid Daubechies, ten lectures on wavelets, (CBMS-NSF regional conference series in applied mathematics, 1992.)
[2] Rafael C. Gonzalez, Richard E. Woods, Steven L. Eddins, digital image processing using matlab, (Pearson Education, 2004.)
[3] The Mathworks Inc., Wavelet Toolbox User Guide, Natick, MA, 2011.
[4] A. Said, W.A. Pearlman, image compression using the spatial-orientation tree, IEEE Int. Symp. on circuits and systems, Chicago, II,
PP.279-282,1993
[5] A. Said, W.A. Pearlman, a new, fast, and efficient image codec based on set partitioning in hierarchical trees, IEEE trans. on circuits
and systems for video technology, vol.6,No.3,pp.243-250,1996
[6] J.M. Shapiro, embedded image coding using zerotrees of wavelet coefficients, IEEE Trans. Signal Proc., vol.41,No.12,pp.3445-
3462,1993.

Analysis of Image Compression Using Wavelet

Recommended

More Related Content

What's hot (20)

Viewers also liked (20)

Similar to Analysis of Image Compression Using Wavelet (20)

More from IOSR Journals (20)

Recently uploaded (20)

Analysis of Image Compression Using Wavelet