HP 300 cone crusher 12 operation taboos.

HP 300 cone crusher 12 operation taboos.

1. It is forbidden to cross iron.

2. After the cone crusher is running normally, the ore feed can be started, and it is forbidden to start the machine with materials.

3. When shutting down, first stop feeding the cone crusher. After all the ore in the crushing cavity is removed, the operation of the crusher motor can be stopped. It is forbidden to stop the machine with materials.

4. During operation, always pay attention to observe whether the current and temperature of the hps300 multi-cylinder hydraulic cone crusher motor are within the rated range. It is forbidden to run the machine with excessive current and low voltage.

5. Always pay attention to observe the operating status of the cone crusher, whether there is any increase in vibration, abnormal noise, whether the connecting bolts are stable, and it is forbidden to continue running when the machine has abnormal noise.

6. Do the pre-operation inspection work before starting up. If an abnormality is found during the inspection, it must be handled before it can be put into operation normally. After the machine is prohibited from running, check and adjust the machine.

7. Adjust the amount of ore supplied by the machine in time to ensure that the material is added evenly and in an appropriate amount, and the machine is prohibited from feeding eccentrically.

8. The size of the material cannot exceed the maximum feeding size in the instruction manual, and it is forbidden to enter large pieces of material in the crushing cavity to prevent "jamming" phenomenon

9. Check the wear of the fixed liner and movable liner, check whether the locking nut of the adjusting seat is loose, and it is forbidden to run the hps300 multi-cylinder hydraulic cone crusher when the nut is not locked.

10. Always observe the ore entering the cone crusher and prohibit "non-crushed objects" from entering the machine to damage the crushing cavity. If "non-crushed objects" are found on the conveyor belt, the operation of the conveyor belt must be stopped immediately, and then the operation of other equipment in turn.

11. Routinely check the lubricating oil in each part according to the specified period. If the oil is insufficient, add it. It is forbidden to run the cone crusher when the oil level of the lubrication station is low.

12. Observe once every half an hour whether the oil supply pressure and oil return volume of the thin oil station are within the normal value, and whether there are impurities such as water in the oil. It is forbidden to run the cone crusher when the lubricating oil filter is blocked.